HP 3PAR StoreServ 7450 Storage Installation Guide

4. Attach the brackets to the side rails (see Figure 14 (page 20)). Be careful not to damage the
data cables.
Figure 14 Attaching the Brackets to the Side Rails
5. Tighten the captive screws (see Figure 15 (page 20)).
NOTE: Make sure the brackets are aligned and leveled with the link connectors before
tightening the captive screws. HP recommends tightening the screws to 19 in-lbs.
Figure 15 Tightening the Captive Screws
20 Setting Up a Factory-Integrated Storage System