HP 3PAR Peer Motion Guide

DescriptionFieldGroup
The port WWN. Displayed if the port is an RCFC port.Remote Port WWN
Indicates whether port mode change from initiator to target or vice versa is Allowed
or Prohibited. This setting is configured using the CLI controlport command.
Mode Change
The number of hosts connected to the port. This is only displayed if the port is
connected to hosts.
Hosts
The number of physical disks connected to the port. This is only displayed if the
port is connected to drive cages.
Physical Disks
The current state of the link. Displayed if the port is an RCFC port.Link State
Primary Internet Storage Name Service server IP address. iSNS protocol allows
for automated discovery, management, and configuration of iSCSI.
Primary IP AddressiSNS Settings
(displayed for
iSCSI ports -
not shown)
The port on the iSNS server with which to communicate.TCP Port
The number of NPIV ports.NPIV PortsNPIV Ports
(displayed for
FC Peer ports)
The WWN of each NPIV port.Port WWN
Click the highlighted value for Connected Device in the General area to display the Host Summary
screen or the System screen, depending on the connected device type.
The Hosts Screen Detail Pane
The detail pane of the Hosts screen displays the following:
DescriptionColumn
The ID of the host associated with the selected port.Host ID
The name of the host system.Host Name
The domain the host is associated with (if any).Domain
The WWN of the port.WWN
The port location in Node:Slot:Port format.Port
Click the highlighted value under Host Name to display the Host Summary screen or the System
screen, depending on the connected device type.
Viewing Storage Settings and Configurations
The Storage Settings and Configurations section of the Peer Motion tree node contains nodes for
Hosts and Security and Domains.
Hosts Node
When you select the Hosts node in the Peer Motion tree, the Hosts and a Host Sets tabs display
in the Management Window.
Storage Settings and Configuration Hosts Screen
The Hosts screen displays source hosts and destination hosts side by side. The source system must
be connected for the source hosts screen in order to display.
Viewing Storage Settings and Configurations 41