HP 3PAR Peer Motion Guide

DescriptionFieldGroup
The name of the system associated with the selected port.Connected Device
Port firmware mode setting. Ports in Initiator mode are connected to drive cages
and ports in Target mode export to hosts. Suspended mode is for target ports that
Mode
have not yet been initialized by the system (this is rare). Peer mode is for Ethernet
ports.
Current state of the port.State
The throughput in KB/s.Total Data
Throughput
Resources
The type of port connection: Host or Peer.Connection ModeSettings
(displayed for
Connection type or port connection setting: Loop or Point.Connection Type
FC and RCFC
ports)
Data transfer rate setting (for example, 1 Gbps). Auto indicates that the system
automatically selects the rate.
Configured Rate
Maximum rate of connection from the port.Max Rate
Indicates whether Fibre Channel service Class 2 is Disabled, Ack 1 or Ack 0.Class 2
For fabric attached ports, indicates the VLUN change notification setting. When
set to Enabled, notices are generated and sent to the fabric controller. When set
to Disabled, no notification is sent.
VCN
Indicates whether the node's WWN is Enabled or Disabled.Unique Node WWN
If disabled, each I/O generates a separate interrupt to the HBA port driver rather
than generating one interrupt for multiple I/O completion.
Interrupt Coalesce
For RCIP ports. The MAC address of the Ethernet interface.MACIP Settings
For iSCSI ports. Indicates if the DHCP protocol is enabled.DHCP
IP address of the iSCSI or RCIP port.IP Address
The address of a local IP router on the same network as the system, used to forward
traffic to destinations beyond the local network.
Gateway
The netmask address for the iSCSI or RCIP interface.Subnet Mask
The greatest amount of data or "packet" size that can be transferred at one time
over a particular network connection without overburdening the connection. The
MTU
default MTU setting for an iSCSI port is 1500. When supported by the network,
an MTU value of 9000 should be used.
For RCIP ports. The configured data transfer rate. A value of 0 indicates that no
data is being transferred.
Configured Rate
For iSCSI ports. Data transfer rate. A value of 0 indicates that no data is being
transferred.
Rate
The TCP port number used by the iSCSI card.TCP Port
(For RCIP) The duplex speed, Half or Full.Duplex
For RCIP ports. Model of the adapter that contains the port (for example, Intel
PRO/1000MT).
Adapter Type
Type of connection (for example, Fabric Attached).TopologyFibre Channel
Settings
Identifies which Fibre Channel classes of service are enabled (2, 3, or 2/3). 2/3
indicates that both Class 2 and Class 3 are enabled.
Class
(displayed for
FC and RCFC
ports)
Model of the Fibre Channel adapter that contains the port (for example, QLOGIC
2302).
Adaptor Type
The node WWN. Displayed if the port is an RCFC port.Remote Node
WWN
40 Using Peer Motion in HP 3PAR Management Console Manager