HP 3PAR Peer Motion Guide

createmigration -sourceuid 2FF70002AC001B0 -srchost "h1" -migtype MDM -destcpg FC_r1
-destprov full
>SUCCESS: Migration job submitted successfully. Please check status/details using
showmigration command.
Migration id: 1397243589759
createmigration -sourceuid 2FF70002AC001BA1 -volmapfile "C:\\testmigrationcommands.txt"
>SUCCESS: Migration job submitted successfully. Please check status/details using
showmigration command.
Migration id: 1397243589759
showmigration
Lists migrations.
DESCRIPTION
The showmigration command lists active migrations in preparation or data transfer phase as
well as the ones that are successful or aborted. By default all migrations are listed. Status of a
migration will show the current state as well as the progress percentage whenever applicable and
failure reason whenever applicable
NOTE: If the showmigration command displays the migration status as failed, this means that
at least one volume migration has failed.
To get details for individual volumes, use the showmigrationdetails command.
For restarting the failed migration, use the startmigration command again with the same
migrationid.
PARAMETERS
Mandatory/optionalDescriptionName
OptionalOnline/MDM/Offline. Display
all migrations that are of the
type specified.
type
OptionalDisplays migrations that are in
the specified state.
status
OptionalUnique number that identifies a
migration after
migrationid
createmigration is
complete. If this is specified,
there is no need to provide
source and destination details.
OptionalThis command can be used to
print delimited output.
csvtable
OptionalRedirects the output of the
command to a file.
filewrite
OptionalDisplays all details with
headings.
all
OptionalAny argument that follows
showcols depicts field to
showcols
display (columns). Accepts a
comma separated list of column
names.
OptionalDisplay the list of column names
applicable to that command.
listcols
These column names can be
100 HP 3PAR Peer Motion Utility Commands