HP 3PAR OpenVMS Implementation Guide (763874-002)

Figure 2 Fibre Channel Port configuration
2. Expand the In servers.
3. Right-click Ports.
The Fibre Channel Port configuration screen appears.
4. Enter the port configuration.
Configuring HP 3PAR array host ports using CLI
1. To determine if a port has already been configured for a host port in fabric mode, run the
following command on the HP 3PAR Storage CLI:
# showport –par
Figure 3 HP 3PAR Storage CLI
2. If the port is not configured, take the port offline before you configure it for connection to a
host OS. To take the port offline, run the HP 3PAR OS CLI command controlport offline
<node:slot:port>.
# controlport offline 1:5:1
Configuring HP 3PAR array host ports using CLI 9