HP 3PAR OpenVMS Implementation Guide (763874-002)

3. To configure the port to the host OS, run controlport config host –ct point
<node:slot:port>, where -ct point indicates that the connection type specified is a
fabric connection.
# controlport config host –ct point 1:5:1
4. Reset the port by entering the controlport rst <node:slot:port> command.
# controlport rst 1:5:1
NOTE: If the array host port is already in point mode, you can skip the steps.
Creating hosts using HP 3PAR Management Console
The Create Host window can be used to create a host.
Figure 4 Create host
1. Enter the Name.
2. Select OpenVMS from Host OS.
By default, Persona changes to 12 - OpenVMS.
3. Click Next.
Step 1
To view the HBA details, run the commands as shown in Figure 5 (page 11).
10 Configuring the HP 3PAR StoreServ Storage system running HP 3PAR OS