MU3 Release Notes

ManualsBrandsHP ManualsSoftwareHP 3PAR Operating System Software

DescriptionItemBug ID

The format of the Logical Block Provisioning Log Page is updated

to match the definition given in recent drafts of the SBC-3 SCSI

specification.

Update LBP Log Page71873

A new property Domains of String[] type is added to

TPD_StorageSystem that contains a list of all the domains that

the current user can see.

Added Domains property to

TPD_StorageSystem that lists all

domains that can seen by the current

user

72077

A new IPAddress property is added for iSCSI

TPD_StorageHardwareID that denotes the IP address of the iSCSI

host.

Added IPAddress property for iSCSI

StorageHardwareID

72078

A new class TPD_StorageDomainGroup is added to model the

domain set. Also, the capability to specify domain a host belongs

to is added to

Added DomainGroup Class and

Capability to Specify Domain during

Host Creation

72079

TPD_StorageHardwareIDManagementService.CreateStorageHardwareIDCollection.

The host domain can be modified via ModifyInstance of

TPD_StorageHardwareIDCollection.

Two methods are added to

StorageHardwareIDManagementService class:

Added SMI-S support for iSCSI host

CHAP configuration

72081

• SetISCSICHAP method allows SMI-S client to set the CHAP

secret of an iSCSI host

• RemoveISCSISHAP method allows SMI-S client to remove the

CHAP secret of an iSCSI host.

The earlier firmware gets a trap and dumps core when specific

errors are injected on the cage connection from the HBA to the

Emulex LPe12004 FW issue72127

MBOD cage. New Emulex LPe12004 FW version 2.01.x10

addresses this issue.

Failed login attempts via CLI client or IMC now include the

username in the Authentication Failure message. In addition,

Username of failed login attempts

recorded in the event log.

72209

event debug capabilities via showeventlog -debug are restricted

to super roles and service roles only.

Make sure that flusher speed is adjusted back to 0 when zero

LD tunes and regular region moves happen simultaneously.

Incorrect flusher speed after tuning.72270

The SSL libraries in use on the system are updated.SSL libraries updated72389

Added support for 450GB (SEGLE0450GBFC15K) PDs in DC3

and DC4 cages.

New drive supported72486

In earlier versions of InForm OS running on V400/V800 systems,

the cluster manager can choose to reboot the wrong node when

Correct handling of node-to-node link

hardware errors

72602

hardware errors are detected on a node-to-node link. This issue

is addressed now.

L1 (top level meta data table) could be out of sync while removing

a snap virtual volume of size 2TB or more (size must be an even

Snap removal after node down could

cause cluster restart

72914

number of TBs, for example 2TB, 4TB, 6TB and so on.) after

node-down which causes node-down recovery failure and whole

system goes down. This is addressed in 3.1.1 MU2 by

synchronizing L1 exception table every time a snap is removed.

This addresses the zero detect reserve buffer pool to ensure that

it uses contiguous memory. This is required if the allocation is

done in interrupt context for large buffer areas.

Correct buffer allocation when in

interrupt context.

This issue may cause an InServ outage.

72949

Earlier versions of InForm OS could return mode pages in

response to a request for page code 3Fh (all pages), which were

Correct handling of supported mode

pages

73010

not accessible when requested using their individual mode pages.

This inconsistency is now addressed.

Modifications to the InForm OS 41