HP 3PAR InForm OS 3.1.1 Concepts Guide

Default value: Please provide contact information such as name, phone number,
and e-mail address
Description: Specifies the name of a person or group responsible for maintaining the storage. This
value can be changed via the manager at any time.
System Name
Access: Read-only
MIB definition: sysName
Data type: Display string (max. 255 characters)
Default value: None
Description: Indicates the system name, which is set during initialization and setup of the system.
This helps to identify this system from other systems. The value cannot be changed by the manager.
System Location
Access: Read/write
MIB definition: sysLocation
Data type: Display string (max. 255 characters)
Default value: Please provide location description where the device resides
such as building, room, and rack number
Description: Contains the user-defined location of the system. This helps to indicate where the
storage system is located. For example, the location may be indicated as follows: Building 1,
room 4, rack 3. This value can be changed via the manager at any time
The HP 3PAR MIB
The HP 3PAR MIB contains proprietary information that reflects the configuration and behavior of
the system and may be useful for network management. Currently, the HP 3PAR MIB only contains
the alertNotify trap definition. Table 9 (page 69) summarizes the contents of this trap.
Table 9 Contents of the alertNotify trap
AccessDescriptionObject Descriptor
Read-onlyTells you which system hardware,
software, or logical component caused
the alert or alert state change.
component
Read-onlyDetailed description of the alert or
alert state change, displayed as an
details
alert string (for example: PR table
<table_name> is corrupt). See
the HP 3PAR InForm OS Messages
and Operator’s Guide for exact
content of all possible alert strings. See
alertNotify Traps“alertNotify Traps”
(page 70) for the exact content of the
alert state change notification string.
Read-onlyNode identification number, an
integer from 0 through 7 that indicates
nodeID
which system controller node reported
the alert or alert state change.
Read-onlySeverity level of the alert or alert state
change, which is an integer from 0 to
severity
5. See the HP 3PAR MIB for definitions
for each integer.
The HP 3PAR SNMP Agent 69