HP 3PAR InForm OS 3.1.1 Command Line Interface Reference

Prevents packet fragmentation when issuing the controlport rcip ping command. This option

can only be used with the rcip ping subcommand.

-portwwn <wwn>

Specifies the Fibre Channel worldwide port name of an attached device for which selective LIP

reset will be performed.

SPECIFIERS

<connmode> disk|host|peer|rcfc|iscsi

Specifies whether the port is used for a disk, host, peer, Remote Copy over Fibre Channel (rcfc),

iSCSI (iscsi) connection. This specifier must be used when issuing the config subcommand.

<ctval>

Specifies the connection parameter of the port. Parameters can be loop or point. The loop

parameter sets the port to arbitrated loop mode, the point parameter sets the port to point-to-point

mode. This specifier must be provided when issuing the ct subcommand.

Specifies the Fibre Channel Class-2 parameter of the port. Parameters can be one of ack0, ack1,

or disable. This specifier must be provided when issuing the cl2 subcommand.

Specifies the data rate of the Fibre Channel port. Rates can be one of 1, 2, 4, or auto. 1 sets the

data rate to 1 GBps, 2 sets the data rate to 2 GBps, and 4 sets the data rate to 4 GBps. The auto

parameter sets the port to autodetect the data rate. This specifier must be used when issuing the

rate subcommand.

Specifies the value of the VCN. The VCN value can be set as enable or disable. This specifier

must be used when issuing the vcn subcommand.

Specifies the IMP port attribute. The IMP value can be set as enable or disable. This specifier

must be used when issuing the imp subcommand.

Specifies if interrupt coalescing is enabled or disabled. The value can be set as enable or

disable. This specifier must be used with the intcoal subcommand.

<N:S:P>

Specifies the port to be controlled.

node

Specifies the node using a number between 0 and 7.

slot

Specifies the PCI bus slot in the specified node using a number between 0 and 5.

port

Specifies the Fibre Channel port number of the PCI card in the specified PCI bus slot using 1 through

<IP_address>

Specifies the IP address for a Remote Copy interface.

<gateway_address>

Specifies the gateway address for a Remote Copy interface.

controlport 91