HP 3PAR InForm OS 3.1.1 Command Line Interface Reference

Specifies that the sums for all volumes of a domain are displayed.
-domain <domainname>...|<pattern>...
Show only the virtual volumes that are in domains with names that match the specified domain
name(s) or pattern(s).
-sortcol <col>[,<dir>][:<col>[,<dir>]...]
Sort command output based on column number (<col>). Columns are numbered from left to right,
beginning with 0. At least one column must be specified. In addition, the direction of sorting
(<dir>) can be specified as follows:
inc
Sort in increasing order (default).
dec
Sort in decreasing order.
Multiple columns can be specified and separated by a colon (:). Rows with the same information
in them as earlier columns will be sorted by values in later columns.
-filt <fspec>
Specifies that statistics that fall below the threshold as specified by the <fspec> arguments, where
<fspec> is <type>, <op>, <meas>, <val>, are filtered out and not displayed. The <type>,
<op>, <meas>, and <val> arguments are separated with one comma.
• <type>
The type argument can be specified with one of the following arguments:
◦ curs
Specifies that only devices with current statistics above the threshold are displayed.
◦ avgs
Specifies that only devices with average statistics above the threshold are displayed.
◦ maxs
Specifies that only devices with maximum values above the threshold are displayed.
• <op>
The operation argument can be specified with one of the following arguments:
◦ r
Specifies that read-only statistics are displayed.
◦ w
Specifies that write-only statistics are displayed.
◦ t|rw
Specifies that statistics for read and write totals are displayed.
statrcvv 567