HP 3PAR InForm OS 3.1.1 Command Line Interface Reference

The columns in the previous example are identified as follows:
• N:S:P. The physical position of the port, in the syntax node:slot:port.
• Connmode.Indicates the connection mode which can be rcfc, peer, host or disk.
• ConnType. Indicates the type of connection configured for the port; loop for loop, point
for point-to-point, or lp for loop or point-to-point.
• CfgRate. The configurable bit rate of data transfer between the port and a host or a disk;
either auto, 1Gbps, 2Gbps, or 4Gbps.
• MaxRate. Indicates the maximum bit rate of transfer between the HBA and the host or disk.
• Class2. Identifies whether class 2 is enabled (ack0 or ack1) or disabled.
• VCN. VLUN State Change Notification support setting. Valid values are n/a, enabled or
disabled. When enabled and in public loop or fabric topology, a Registered State Change
Notification (RSCN) message is issued to the fabric controller whenever a VLUN is created
or removed.
• IntCoal. Indicates whether the interrupt coalesce setting is Enabled or Disabled.
The following example displays information about all Remote Copy ports:
cli% showport –rc
N:S:P State HwAddr Rate Type
5:3:2 ready 25320002AC000006 2Gbps rcip
4:1:1 ready 24110002AC000006 2Gbps rcip
0:5:1 ready 0002B39B2013 100Mbps rcip
The columns in the previous example are identified as follows:
• N:S:P. The physical position of the port, in the syntax node:slot:port.
• State. State of the port.
config_wait. Configuration waiting.◦
◦ alpa_wait. ALPA waiting.
◦ login_wait. Login waiting.
◦ ready. Link is ready.
◦ loss_sync. Link loss sync.
◦ error. Currently in an error state.
◦ non_participate. Link not participating.
◦ taking_coredump.Coredump in progress.
◦ offline. Link is offline.
◦ fw_dead. Firmware dead.
◦ link_idle_for_reset. Link is idle for reset.
◦ dhcp_in_progress. DHCP is in progress.
◦ pending_reset. Link reset is pending.
◦ unknown. Link state is unknown.
442 Show Commands