HP 3PAR InForm OS 3.1.1 Command Line Interface Reference

0:0:1 initiator ready 2FF70002AC00000A 20010002AC00000A disk
0:0:2 initiator ready 2FF70002AC00000A 20020002AC00000A disk
0:0:3 initiator ready 2FF70002AC00000A 20030002AC00000A disk
0:0:4 initiator loss_sync 2FF70002AC00000A 20040002AC00000A free
0:2:1 initiator ready 2FF70002AC00000A 20210002AC00000A host
0:2:2 target ready 2FF70002AC00000A 20220002AC00000A host
0:4:1 peer offline - 0002B3A99F7E rcip
0:5:1 initiator loss_sync 2FF70002AC00000A 20510002AC00000A free
0:5:2 initiator loss_sync 2FF70002AC00000A 20520002AC00000A free
1:0:1 initiator ready 2FF70002AC00000A 21010002AC00000A disk
1:0:2 initiator ready 2FF70002AC00000A 21020002AC00000A disk
1:0:3 initiator ready 2FF70002AC00000A 21030002AC00000A free
1:0:4 initiator loss_sync 2FF70002AC00000A 21040002AC00000A free
1:2:1 initiator ready 2FF70002AC00000A 21210002AC00000A host
1:2:2 initiator ready 2FF70002AC00000A 21220002AC00000A disk
1:3:1 target ready - 00C0DD077977 iscsi
1:3:2 target loss_sync - 00C0DD077979 iscsi
1:4:1 peer offline - 0002B3BCE77D rcip
1:5:1 target ready 2FF70002AC00000A 21510002AC00000A host
1:5:2 target loss_sync 2FF70002AC00000A 21520002AC00000A free
The columns in the previous example are identified as follows:
• N:S:P. The physical position of the port, in the syntax node:slot:port.
• Mode. Indicates whether the port is an initiator, target,or peer. Initiators connect to
disks (default) and target ports connect to hosts or fabrics. A target port that has yet to be
initialized by the system appears as suspended. Ethernet ports use peer mode for Remote
Copy.
• State. State of the port. Possible values vary according to whether the port is an Ethernet or
Fibre Channel port.
◦ config_wait. Configuration waiting.
◦ alpa_wait. ALPA waiting.
◦ login_wait. Login waiting.
◦ ready. Link is ready.
◦ loss_sync. Link loss sync.
◦ error. Currently in an error state.
◦ non_participate. Link not participating.
◦ taking_coredump.Coredump in progress.
◦ offline. Link is offline.
◦ fw_dead. Firmware dead.
◦ link_idle_for_reset. Link is idle for reset.
◦ dhcp_in_progress. DHCP is in progress.
◦ pending_reset. Link reset is pending.
◦ unknown. Link state is unknown.
• Node_WWN. The WWN that belongs to the controller node identified in the N:S:P column.
440 Show Commands