HP 3PAR InForm OS 3.1.1 Command Line Interface Reference

showport
DESCRIPTION
The showport command displays information about ports in the system.
SYNTAX
The syntax of the showport command can be one of the following:
• showport [options] [-failed] [-sortcol
<col>[,<dir>]][<node:slot:port> |<pattern>...]
AUTHORITY
Any role in the system.
OPTIONS
-i
Show hardware and inventory formation.
-c
Displays all devices connected to each loop (by position on the loop). Position 0 is the cage
connected directly to the node on this loop.
Position n is the (n + 1) cage on the loop. Thus a “pos” value of 1 means this cage is the second
cage away from the node on the loop. Example:
Node --> 0th cage --> 1st cage --> 2nd cage --> 3rd cage
-par
Displays a parameter listing such as the configured data rate of a port and the maximum data rate
that the card supports. Also shown is the type of attachment (Direct Connect or Fabric Attached)
and whether the unique_nwwn and VCN capabilities are enabled.
-rc
Displays information that is specific to the Remote Copy ports.
-rcfc
Displays information that is specific to the Fibre Channel Remote Copy ports.
-peer
Displays information that is specific to the Fibre Channel ports for Data Migration.
-rcip
Displays information specific to the Ethernet Remote Copy ports.
-iscsi
Displays information about iSCSI ports.
-iscsiname
Displays iSCSI names associated with iSCSI ports.
-fcoe
Displays information that is specific to Fibre Channel over Ethernet (FCoE) ports.
-sfp
Displays information about hot pluggable SFPs attached to ports.
-ddm
Displays information about the SFPs DDM. This option must be used with the -sfp option.
438 Show Commands