HP 3PAR InForm OS 3.1.1 Command Line Interface Reference

Specifies detailed information in verbose format. It can be used with any of the following component
options:
-fan
Displays the node fan information.
–pci
Displays PCI card information.
–cpu
Displays CPU information.
–mem
Displays physical memory information.
-drive
Displays the disk drive information.
–ps
Displays power supply information.
-mcu
Displays MicroController Unit information.
–s
Displays the detailed state information for node or power supply (proceed with the -ps option)
SPECIFIERS
<node_ID>...
Displays the node information for the specified node ID(s). This specifier is not required.
Restrictions
None.
EXAMPLES
The following example displays the operating environment status for all nodes in the system:
cli% shownode
Control Data Cache
Node --Name-- -State- Master InCluster ---LED--- Mem(MB) Mem(MB) Available(%)
0 enodec34 OK Yes Yes GreenBlnk 2048 2048 100
1 enodec33 OK No Yes GreenBlnk 2048 2048 100
In the example above:
• Node. The node ID.
• Name. The node name.
• State. The state of the node. Values are as follows:
--. Cannot determine the overall node state.◦
◦ OK. The node and its components are operating normally.
408 Show Commands