HP 3PAR InForm OS 3.1.1 Command Line Interface Reference

–natural
When issuing the command with the reverse specifier, only the natural direction of the groups
is reversed, leaving the current direction unchanged.
–current
When issuing the setrcopygroup command with the reverse subcommand, only the current
direction of the groups is reversed.
–waittask
Wait for all tasks created by this command to complete before returning. This option applies to
the failover, recover, restore, and reverse subcommands.
-pat
Specifies that specified patterns are treated as glob-style patterns and all Remote Copy groups
matching the specified pattern will be set. The -pat option can specify a list of patterns. This option
must be used if <pattern> specifier is used.
SPECIFIERS
<pattern>
Specifies a glob-style pattern (see help on sub,globpat). If this specifier is not used, the
<group_name> or <target_name> specifier must be used.
<policy>
Specifies the policy to assign to the group. This specifier can only be used with the pol
subcommand. Valid policies are:
fail_wrt_on_err
Specifies that if Remote Copy is started for the volume group and a write to the secondary system
fails, then an I/O error is returned to the host.
no_fail_wrt_on_err
Specifies that if Remote Copy is started for the volume group and a write to the secondary system
fails, then the Remote Copy operation is stopped and an I/O error is not returned to the host
(default). This allows the application writing the data to continue, but makes the secondary volumes
out of date with the primary volumes.
auto_recover
Specifies that if the Remote Copy is stopped as a result of the Remote Copy links going down, the
group is restarted automatically after the links come back up. If this policy is enabled for a group
while the group is stopped after link failures it will be only be started when the links come up for
the failed target. If the links are already up at the time the policy is set then the group will not be
restarted at that time.
no_auto_recover
Specifies that if the Remote Copy is stopped as a result of the Remote Copy links going down, the
group must be restarted manually after the links come back up (default).
over_per_alert
If a synchronization of a periodic Remote Copy group takes longer to complete than its
synchronization period then an alert will be generated. This is the default behavior.
no_over_per_alert
If a synchronization of a periodic Remote Copy group takes longer to complete than its
synchronization period, an alert will not be generated.
NOTE: When issuing the setrcopygroup <dr_operation> command, either the <group_name>
specifier or the <target_name> specifier must be specified.
setrcopygroup 317