HP 3PAR InForm OS 3.1.1 Command Line Interface Reference

Specifies one or more PCI slots. Slots are identified by one or more integers (item). Multiple slots
are separated with a single comma (1,2,3). A range of slots is separated with a hyphen (0–7).
The primary path of the disks must be on the specified PCI slot(s).
–pt <item>
Specifies one or more ports. Ports are identified by one or more integers (item). Multiple ports
are separated with a single comma (1,2,3). A range of ports is separated with a hyphen (0–4).
The primary path of the disks must be on the specified port(s).
–cg <item>
Specifies one or more drive cages. Drive cages are identified by one or more integers (item).
Multiple drive cages are separated with a single comma (1,2,3). A range of drive cages is
separated with a hyphen (0–3). The specified drive cage(s) must contain disks.
–mg <item>
Specifies one or more drive magazines. The 1. or 0. displayed in the CagePos column of showpd
output indicating the side of the cage is omitted when using -mg option. Drive magazines are
identified by one or more integers (item). Multiple drive magazines are separated with a single
comma (1,2,3). A range of drive magazines is separated with a hyphen (0–3). The specified
drive magazine(s) must contain disks.
–pn <item>
Specifies one or more disk positions within a drive magazine. Disk positions are identified by one
or more integers (item). Multiple disk positions are separated with a single comma (1,2,3). A
range of disk positions is separated with a hyphen (0–3). The specified position(s) must contain
disks.
–dk <item>
Specifies one or more physical disks. Disks are identified by one or more integers (item). Multiple
disks are separated with a single comma (1,2,3). A range of disks is separated with a hyphen
(0–3). Disks must match the specified ID(s).
NOTE: The following options are used to select the disks that are used to create common
provisioning groups based on the characteristics of the disk.
–tc_gt <number>
Specifies that physical disks with total chunklets greater than the number specified are selected.
–tc_lt <number>
Specifies that physical disks with total chunklets less than the number specified are selected.
–fc_gt <number>
Specifies that physical disks with free chunklets greater than the number specified are selected.
–fc_lt <number>
Specifies that physical disks with free chunklets less than the number specified are selected.
–devid <model>
Specifies that physical disks identified by their models are selected. Models can be specified in a
comma-separated list. Models can be displayed by issuing the showpd -i command.
–devtype <type>
Specifies that physical disks must have the specified device type (FC for Fibre Channel, NL for
Nearline, or SSD for Solid State Drive) to be used. Device types can be displayed by issuing the
showpd command. If it is not specified, the default device type is FC.
-rpm <number>
Disks must be of the specified speed. Device speeds are shown in the RPM column of the showpd
command. The number does not represent a rotational speed for the drives without spinning media
292 Set Commands