HP 3PAR InForm OS 3.1.1 Command Line Interface Reference

setclienv
DESCRIPTION
The setclienv command sets the CLI environment parameters.
SYNTAX
setclienv <parameter> <value>
AUTHORITY
• Super, Service, Edit, Browse
• Any role granted the clienv_set right.
OPTIONS
None.
SPECIFIERS
The specifiers include the parameters and values to which the parameters should be set. Valid
parameters and their values are as follows:
<value><parameter>
Enter one of the following:currentdomain
• The name of the domain that you wish to set as the
working domain for the current CLI session.
• -unset to set no current domain.
Enter one of the following:listdom
• 0 - (Default) Do not include the domain column in the
output.
• 1 - Include domain column where relevant.
Enter one of the following:csvtable
• 0 - (Default) Normal table printing format.
• 1 - Comma Separated Values (CSV) format.
Enter one of the following:nohdtot
• 0 - (Default) Show header and total lines.
• 1 - Does not show the header and total lines.
<nlines> - Specifies the number of lines of data to display
before an output header is displayed. If <nlines> is 10 or
hafter
more, print the header after every <nlines> of data. If
<nlines> is less than 10, print only the header at the
beginning.
<nlines> - For the hist and stat commands, specifies
the number of lines of data to display as soon as the data
histstatnum
is available. Default is 5000 if histstatnum is not set or set
to 0. The data sorting will be within the <histstatnum> rows.
NOTE: This parameter is only supported when connected
via SSH. Specifies the command line editing mode. Enter
one of the following:
editor
• emacs - (Default) Use emacs-style line editing.
• vi - Use v-style line editing.
288 Set Commands