HP 3PAR InForm OS 3.1.1 Command Line Interface Reference

Array and Controller Node Information
For Details SeeAuthorityDescriptionCommand
“locatenode” (page 212)Super, Service
1
Locates a particular node
component by blinking LEDs
on the node.
locatenode
Any role granted the
node_locate right.
“locatesys” (page 213)Super, Service
1
Locates a system by blinking
its LEDs.
locatesys
Any role granted the
sys_locate right.
“setsys” (page 332)Super, Service
1
Enables you to set
system-wide parameters such
as the raw space alert.
setsys
Any role granted the
sys_set right.
“showsys” (page 475)Any role in the system.Displays the HP 3PAR
Storage System properties,
showsys
including system name,
model, serial number, and
system capacity.
1
You need access to all domains in order to run this command.
Network Interface Configuration
For Details SeeAuthorityDescriptionCommand
“setnet” (page 306)Super, Service
1
Any role granted the
net_set right.
Sets the administration
network interface
configuration.
setnet
“setntp” (page 311)Super, Service
1
Any role granted the
ntp_set right.
Sets the NTP server to which
the HP 3PAR Storage System
synchronizes.
setntp
“shownet” (page 405)Any role in the system.Displays the network
configuration and status.
shownet
1
You need access to all domains in order to run this command.
Port Information
For Details SeeAuthorityDescriptionCommand
“checkport” (page 67)Super, Service
1
Performs a loopback test on
Fibre Channel ports.
checkport
Any role granted the
port_check right.
“controlport” (page 87)Super, Service
1
Controls Fibre Channel or
Remote Copy ports.
controlport
Any role granted the
port_control right.
port_control
“controliscsiport” (page 81)Super, Edit
1
Used to set up the
parameters and
controliscsiport
Any role granted the
port_control right.
characteristics of an iSCSI
port.
“showiscsisession”
(page 390)
Any role in the system.Shows the iSCSI active
sessions per port.
showiscsisession
Node Subsystem Management Commands 25