HP 3PAR InForm Management Console 4.2.1 Software User's Guide (QL226-96251, December 2011)

Lower Pane
The lower pane provides detail information about a selected port from the upper pane. Information
is presented on up to four tabs, which includes a Summary tab, and, depending on your system
setup, Physical Disks, SFP, Sessions, or Hosts. Each are discussed in detail in the following:
“Port Details Summary” (page 87)
“Physical Disks” (page 96)
“SFP” (page 101)
“Sessions” (page 105)
“Hosts” (page 105)
Port Details Summary
The port details summary is presented on the Summary tab.
The Summary tab provides the following information:
DescriptionFieldGroup
Port location.LocationGeneral
For iSCSI ports. Port location.Position (not shown)
Port World Wide Name.Port WWN
Node World Wide Name.Node WWN
Indicates whether the port is FC, iSCSI, RCIP, or RCFC.Type
Rate that data can be transferred over the port (1 Gbps, 2 Gbps or 4
Gbps). When there is no specified value, no connection exists.
Rate
Type of device that the port is connected to. Free, Disk, Host, Peer, or
InServ.
Connected Device Type
Name of device that the port is connected to, e.g. host1, cage0.Connected Device
Port firmware mode setting. Ports in Initiator mode are connected to drive
cages and ports in Target mode export to hosts. Suspended mode is for
Mode
target ports that have not yet been initialized by the system (rare). Peer
mode is for Ethernet ports.
Current state of the port.State
Viewing System Ports 87