HP 3PAR Command Line Interface Reference (OS 3.1.2 MU2) (QL226-97016, June 2013)

NOTES
• The setrcopytarget command requires the groups associated with it be stopped prior to
using the following options:
◦ setrcopytarget name <new_name> <target_name>
◦ setrcopytarget tput <throughput> <target_name>
• The setrcopytarget command with the following arguments can be run without bringing
down its Remote Copy groups:
◦ setrcopytarget pol <policy> <target_name>
◦ setrcopytarget tunelinks <bandwidth> <latency> <target_name>
• Under normal operating conditions the mirror_config policy should never be changed to
no_mirror_config. This policy option is included only as a method to correct several
unusual error conditions that might occur in the course of operation which result in a mismatch
in configuration between the two sides of a Remote Copy pair. For instance, it is possible for
a group to be created, or a volume to be added to a group, only on one side of the pair if
the operation is interrupted by a network failure. In such cases it might be necessary to
temporarily change the policy to no_mirror_config in order to bring the configurations
into alignment. After being corrected the mirror_config policy should be immediately
restored. Such operations should generally only be undertaken on the advice of a HP
representative.
setrcopytarget 321