HP 3PAR AIX and IBM Virtual I/O Server Implementation Guide

0:4:1 host point auto 4Gbps disabled disabled disabled enabled
0:4:2 host point auto 4Gbps disabled disabled disabled enabled
0:5:1 host point auto 2Gbps disabled disabled disabled enabled
0:5:2 host loop auto 2Gbps disabled disabled disabled enabled
0:5:3 host point auto 2Gbps disabled disabled disabled enabled
0:5:4 host loop auto 2Gbps disabled disabled disabled enabled
1:0:1 disk loop auto 2Gbps disabled disabled disabled enabled
1:0:2 disk loop auto 2Gbps disabled disabled disabled enabled
1:0:3 disk loop auto 2Gbps disabled disabled disabled enabled
1:0:4 disk loop auto 2Gbps disabled disabled disabled enabled
1:2:1 host point auto 2Gbps disabled disabled disabled enabled
1:2:2 host loop auto 2Gbps disabled disabled disabled enabled
1:4:1 host point auto 2Gbps disabled disabled disabled enabled
1:4:2 host point auto 2Gbps disabled disabled disabled enabled
1:5:1 host loop auto 4Gbps disabled disabled disabled enabled
1:5:2 host loop auto 4Gbps disabled disabled disabled enabled
1:5:3 host loop auto 4Gbps disabled disabled disabled enabled
1:5:4 host loop auto 4Gbps disabled disabled disabled enabled
Configuring Ports on the HP 3PAR StoreServ Storage for a Fabric Connection
To configure HP 3PAR StoreServ Storage ports for a fabric connection, complete the following
steps for each port connecting to a fabric.
1. To determine whether a port has already been configured for a host port in fabric mode, issue
showport -par on the HP 3PAR StoreServ Storage.
#showport -par
N:S:P Connmode ConnType CfgRate MaxRate Class2 UniqNodeWwn VCN IntCoal
0:0:1 disk loop auto 2Gbps disabled disabled disabled enabled
0:0:2 disk loop auto 2Gbps disabled disabled disabled enabled
0:0:3 disk loop auto 2Gbps disabled disabled disabled enabled
0:0:4 disk loop auto 2Gbps disabled disabled disabled enabled
0:4:1 host point auto 4Gbps disabled disabled disabled enabled
0:4:2 host point auto 4Gbps disabled disabled disabled enabled
0:5:1 host point auto 2Gbps disabled disabled disabled enabled
0:5:2 host loop auto 2Gbps disabled disabled disabled enabled
0:5:3 host point auto 2Gbps disabled disabled disabled enabled
0:5:4 host loop auto 2Gbps disabled disabled disabled enabled
1:0:1 disk loop auto 2Gbps disabled disabled disabled enabled
1:0:2 disk loop auto 2Gbps disabled disabled disabled enabled
2. If the port has not been configured, take the port offline before configuring it for connection
to a host server. To take the port offline, issue the HP 3PAR OS CLI command controlport
offline <node:slot:port>.
# controlport offline 1:5:1
3. To configure the port to the host server, issue controlport config host -ct point
<node:slot:port>, where -ct point indicates that the connection type specified is a
fabric connection. For example:
# controlport config host -ct point 1:5:1
4. Reset the port by issuing the controlport rst <node:slot:port> command.
# controlport rst 1:5:1
8 Configuring the HP 3PAR StoreServ Storage for Fibre Channel