3PAR InForm® OS 2.3.1 Messages and Operator's Guide (320-200181 Rev B, February 2010)

12.84
Messages and Operator’s Guide InForm OS Version 2.3.1
MESSAGE 11
Firmware panic due to PMC read failure. Panic count is <count>
(<code>).
SUGGESTED ACTION
Internal midplane hardware error. If you receive this alert, then cage completed self recovery.
If error persists, replace midplane.
MESSAGE 12
Firmware panic due to PMC write failure. Panic count is <count>
(<code>).
SUGGESTED ACTION
Internal midplane hardware error. If you receive this alert, then cage completed self recovery.
If error persists, replace midplane.
MESSAGE 13
Firmware panic due to generic POST failure. Panic count is <count>
(<code>).
SUGGESTED ACTION
Internal midplane hardware error. If you receive this alert, then cage completed self recovery.
If error persists, replace midplane.
MESSAGE 14
Firmware panic due to SRAM test failure. Panic count is <count>
(<code>).
SUGGESTED ACTION
Internal midplane hardware error. If you receive this alert, then cage completed self recovery.
If error persists, replace midplane.
MESSAGE 15
Midplane PMC <ID> Revision <rev> not supported.
SUGGESTED ACTION
Internal midplane hardware error. Replace midplane.
MESSAGE 16
POST IRQ Init <error> <code>.