3PAR InForm® OS 2.3.1 CLI Reference (320-200166 Rev B, March 2010)

30.2
Command Line Interface Reference InForm OS Version 2.3.1
COMMAND
upgradecage
DESCRIPTION
The upgradecage command downloads new firmware into the specified cage.
SYNTAX
The syntax for the upgradecage command can be one of the following:
upgradecage [options <arg>] <cagename>...
upgradecage [options <arg>] -a
AUTHORITY
Super, Service
OPTIONS
–a
Specifies that all drive cages are upgraded with new firmware (<cagename> should not be
specified).
–noA
Do not upgrade the A loop. This option is only valid for DC1 cages.
–noB
Do not upgrade the B loop. This option is only valid for DC1 cages.
-skiptest
Skips the 10 second per PD diagnostic test normally completed after each cage upgrade.
–model <model>
Only upgrade cages of specified model. Use showcage command to find out the correct
model for the cages. The model can be DC1, DC2, DC3, or DC4.
NOTE: You need access to all domains in order to run this command.