3PAR InForm® OS 2.3.1 CLI Reference (320-200166 Rev B, March 2010)

28.3
InForm OS Version 2.3.1 Command Line Interface Reference
OPTIONS
The following options can be used on all commands:
–f
Forces the command. The command completes without prompting for confirmation.
–waittask
Specifies that the command will wait for any created tasks to complete.
The following options cannot be used with the
restart or rollback subcommands:
–cpg <CPG_name>
Name of the Common Provisioning Group (CPG) to which the snapshot data space is
moved. If the
-cpg option is specified, only the snapshot data space of a volume is tuned.
When snapshot data space is tuned, the only permitted option is the
–cnt option. If this
option is not specified, only the USR space of a volume is tuned.
–templ <template_name>
Use the options defined in template <template_name>. The template is created using the
createtemplate command. Options specified in the template are read-only or read-
write. The read-write options may be overridden with new options at the time of their
creation, but read-only options may not be overridden at creation time. Options not
explicitly specified in the template take their default values, and all of these options are
either read-only or read-write (using the
–nro or –nrw options of the createtemplate
command). Sizing options from the template are ignored. This command does not change
the size of the VV on which it acts.
–t <RAID_type>
Specifies the RAID type of the Logical Disk (LD): r0 for RAID-0, r1 for RAID-1, or r5 for
RAID-5, or
r6 for RAID-6. If no RAID type is specified, the default is r1.
–ssz <size_number_chunklets>
Specifies the set size in the number of chunklets. The default depends on the RAID type
specified:
2 for RAID-1, 4 for RAID-5, and 8 for RAID-6.
–rs <size>
Specifies the number of sets in a row. The <size> is a positive integer. If not specified, no
row limit is imposed.