3PAR InForm® OS 2.3.1 CLI Reference (320-200166 Rev B, March 2010)

25.43
InForm OS Version 2.3.1 Command Line Interface Reference
(1,2,3). The list can also consist of a single integer (1). If the node_list is not specified, all
disks on all nodes are displayed.
–slots <slot_list>
Specifies that the display is limited to specified PCI slots and PDs connected to those PCI
slots. The
slot_list is specified as a series of integers separated by commas (1,2,3). The
list can also consist of a single integer (
1). If the slot list is not specified, all disks on all slots
are displayed.
–ports <port_list>
Specifies that the display is limited to specified port slots and PDs connected to those port
slots. The
port_list is specified as a series of integers separated by commas (1,2,3). The
list can also consist of a single integer (
1). If the port list is not specified, all disks on all ports
are displayed.
–lw
Lists the host’s World Wide Name (WWN) or iSCSI names. This is especially useful when
multiple WWNs or iSCSI names belonging to the same host are visible on the same port.
–domainsum
Specifies that sums for VLUNs are grouped by domain in the display. All VLUNs to unnamed
hosts are added and displayed as a single set of data with a "
-" host name.
–vvsum
Specifies that sums for VLUNs of the same VV are displayed.
–hostsum
Specifies that sums for VLUNs are grouped by host in the display. All VLUNs to unnamed
hosts are added and displayed as a single set of data with a nameless host.
–rw
Specifies reads and writes to be displayed separately. If this option is not used, then the
total of reads plus writes is displayed.
–d <secs>
Specifies the interval, in seconds, that statistics are sampled using an integer from 1
through 2147483. If no interval is specified, the option defaults to an interval of two
seconds.