3PAR InForm® OS 2.3.1 CLI Reference (320-200166 Rev B, March 2010)

21.79
InForm OS Version 2.3.1 Command Line Interface Reference
COMMAND
setsysmgr
DESCRIPTION
The setsysmgr command sets the system manager startup state.
SYNTAX
The syntax of the setsysmgr command can be one of the following:
■ setsysmgr wipe [-f] <system_name> [<system_ID>]
■ setsysmgr tocgen [-f] [<toc_gen_number> [<disk_quorum>]]
■ setsysmgr force_iderecovery [-f]
■ setsysmgr force_idewipe [-f]
AUTHORITY
Super
SUBCOMMANDS
wipe
Requests that the specified system be started in the new system state. If this subcommand is
not used, then the tocgen subcommand must be used.
tocgen
Specifies that the system is to be started with the specified table of contents generation
number. If this subcommand is not used, then the
wipe subcommand must be used.
force_iderecovery
Specifies that the system starts the recovery process from the IDE disk even if all Virtual
Volumes (VV) have not been started.
CAUTION: Issuing the setsysmgr command can potentially remove the entire
state of the system causing data loss.
NOTE: You need access to all domains in order to run this command.