3PAR InForm® OS 2.3.1 CLI Reference (320-200166 Rev B, March 2010)

21.77
InForm OS Version 2.3.1 Command Line Interface Reference
RemoteSyslogHost <value>
Sets the IP address of the system to which events will be sent as syslog messages. The value
must be a valid IP address.
SparingAlgorithm <value>
Sets the sparing algorithm used by the admithw command. Valid values are Default,
Minimal, Maximal, and Custom.
MgmtOldPorts <value>
Enables or disables listening on the old management ports 2540 and 2550 (for SSL). The
server now listens on ports
5782 and 5783 (for SSL). By default, the server also listens on
the old ports unless they are disabled using this parameter. The value must be either
enable or disable. Default ports 2540 and 2550 were deprecated in the 2.2.4 release
and support for them will be removed in a future release.
RemoteCopyOldPort <value>
Enables or disables listening on the old TCP port 3491. The value must be either enable or
disable. By default, remote copy links listen on both IANA registered port 5785 AND port
3491.
CopySpaceReclaim <value>
Enable the system to reclaim unused snapshot copy space if the <value> argument is set to
1. The default is 1 for a newly installed system with InForm 2.3.1 or later, and 0 if the system
had been upgraded from any version prior to 2.3.1. Once the <value> argument is set to 1,
setting it back to 0 is not allowed. Downgrading to a software release prior to 2.3.1 if
<value> is 1 will fail if there is any VVs in the system with reclaimed snapshot copy space.
If the downgrade fails, refer to the CLI Administrator’s Manual for instructions to enable
the downgrade.
NOTE: The server must be restarted for changes made with the MgmtOldPorts
parameter to take effect.
WARNING: Changing this parameter will reset all remote copy links. This may
cause remote copy targets to lose their connections temporarily.