3PAR InForm® OS 2.3.1 CLI Reference (320-200166 Rev B, March 2010)

21.58
Command Line Interface Reference InForm OS Version 2.3.1
Wait for all tasks created by this command to complete before returning. This option
applies to the
failover, recover, restore, and reverse subcommands.
SPECIFIERS
<policy>
Specifies the policy to assign to the group. This specifier can only be used with the pol
subcommand. Valid policies are:
fail_wrt_on_err
Specifies that if Remote Copy is started for the volume group and a write to the
secondary system fails, then an I/O error is returned to the host.
no_fail_wrt_on_err
Specifies that if Remote Copy is started for the volume group and a write to the
secondary system fails, then the Remote Copy operation is stopped and an I/O error
is not returned to the host (default). This allows the application writing the data to
continue, but makes the secondary volumes out of date with the primary volumes.
auto_recover
Specifies that if the Remote Copy is stopped as a result of the Remote Copy links
going down, the group is restarted automatically after the links come back up. If this
policy is enabled for a group while the group is stopped after link failures it will be
only be started when the links come up for the failed target. If the links are already
up at the time the policy is set then the group will not be restarted at that time.
no_auto_recover
Specifies that if the Remote Copy is stopped as a result of the Remote Copy links
going down, the group must be restarted manually after the links come back up
(default).
over_per_alert
If a synchronization of a periodic Remote Copy group takes longer to complete than
its synchronization period then an alert will be generated. This is the default
behavior.
no_over_per_alert
If a synchronization of a periodic Remote Copy group takes longer to complete than
its synchronization period then an alert will not be generated.