3PAR InForm® OS 2.3.1 CLI Reference (320-200166 Rev B, March 2010)

16.3
InForm OS Version 2.3.1 Command Line Interface Reference
<port_name>
Indicates the port specifiers. Accepted values are A0|B0|A1|B1|A2|B2|A3|B3. If a port is
specified, the port LED will oscillate between green and off. The
<port_name> specifier is
not supported for DC3 drive cages.
<mag>
Indicates the drive magazine by number.
◆ For DC1 drive cages, accepted values are 0 through 4.
◆ For DC2 and DC4 drive cages, accepted values are 0 through 9.
◆ For DC3 drive cages, accepted values are 0 through 15.
RESTRICTIONS
■ Access to all domains is required to run this command.
■ The <port_name> specifier is not supported for DC3 drive cages.
EXAMPLES
The following example causes the Fibre Channel LEDs on the drive cage cage0 to blink for 20
seconds:
NOTES
■ Issue the showcage command for a list of cage names.
■ If no port or magazine is specified, all LEDs in the cage are set as amber or oscillate
(depending on the cage type).
■ If the port is specified, it turns green (not available in all cage types).
cli% locatecage –t 20 cage0