3PAR InForm® OS 2.3.1 CLI Reference (320-200166 Rev B, March 2010)

15.13
InForm OS Version 2.3.1 Command Line Interface Reference
<val_ms>
Specifies the threshold service time in milliseconds.
<count>
Specifies the minimum number of access above the threshold service time.
–ni
Specifies that histograms for only nonidle devices are displayed. This option is shorthand
for the option
–filt t,0,0.
–p <pattern>
Specifies the pattern of PDs displayed in the histogram. Patterns are used to filter and
select the disks displayed in the histogram. If specified multiple times, each instance of the
specified pattern adds additional candidate disks that match the pattern:
–nd <item>
Specifies one or more nodes. Nodes are identified by one or more integers (item).
Multiple nodes are separated with a single comma (
1,2,3). A range of nodes is
separated with a hyphen (
0–7). The primary path of the disks must be on the
specified node number(s).
–st <item>
Specifies one or more PCI slots. Slots are identified by one or more integers
(
<item>). Multiple slots are separated with a single comma (1,2,3). A range of
slots is separated with a hyphen (
0–7). The primary path of the disks must be on the
specified PCI slot number(s).
–pt <item>
Specifies one or more ports. Ports are identified by one or more integers (<item>).
Multiple ports are separated with a single comma (
1,2,3). A range of ports is
separated with a hyphen (
0–5). The primary path of the disks must be on the
specified port number(s).
NOTE: An item is specified as an integer, a comma-separated list of integers, or a
range of integers specified from low to high.