3PAR InForm® OS 2.3.1 CLI Reference (320-200166 Rev B, March 2010)

14.3
InForm OS Version 2.3.1 Command Line Interface Reference
–szs <size>[g|G|t|T]
Specifies the size of the snapshot volume in megabytes using an integer between 0 and
67108864 (65536 GB). Size can optionally be specified in gigabytes or terabytes by
providing either the
g or G options (for gigabytes) and t or T options (for terabytes)
following (no whitespace between) the entered size value. This option cannot be used with
the
-pct option. This option is deprecated and will be removed in a subsequent release.
–sza <size>[g|G]
Specifies the size of the administration volume in megabytes using an integer between
0 and 524288 (512 GB). Size can optionally be specified in gigabytes by providing either
the g or G options following (no whitespace between) the entered size value. This option
cannot be used with the
-pct option. This option is deprecated and will be removed in a
subsequent release.
–f
Suppresses the requested confirmation before growing a virtual volume with a different
RAID type than the last region of the existing virtual volume.
–t <RAID_type>
Specifies the RAID type with r0, r1, r5 or r6. If not specified, the default RAID type is the
same as the last region of the existing virtual volume. Specifying a different RAID type than
the existing virtual volume results in a warning message and a prompt for confirmation
unless the
–f option is specified.
–ssz <size_number_chunklet>
Specifies the set size in terms of chunklets. The default depends on the RAID type specified.
If the RAID type is not specified or if the same RAID type as the last region of the existing
virtual volume is specified, the default is the same set size as the last region of the existing
VV. Otherwise, the default is
2 for RAID-1, 4 for RAID-5, and 8 for RAID-6.
–rs <size>
Specifies the number of sets in a row for each logical disk using an integer between 1 and
2147483647. If not specified, no row limit is imposed.