3PAR InForm® OS 2.3.1 CLI Reference (320-200166 Rev B, March 2010)

11.25
InForm OS Version 2.3.1 Command Line Interface Reference
–ch first|last
Specifies the chunklet location characteristics, either first (lowest numbered available
chunklets) or
last (highest numbered available chunklets). If no argument is specified, the
default characteristic is
first.
–p <pattern>
Specifies a pattern for candidate disks. Patterns are used to select disks that are used for
creating logical disks. If no pattern is specified, the option defaults to all Fibre Channel (FC)
disks. If specified multiple times, each instance of the specified pattern adds additional
candidate disks that match the pattern. The
-devtype pattern cannot be used to mix Near
Line (NL), FC, and Solid State Drive (SSD) drives:
–nd <item>
Specifies one or more nodes. Nodes are identified by one or more integers (item).
Multiple nodes are separated with a single comma (
1,2,3). A range of nodes is
separated with a hyphen (
0–7). The primary path of the disks must be on the
specified node number(s).
–st <item>
Specifies one or more PCI slots. Slots are identified by one or more integers (item).
Multiple slots are separated with a single comma (
1,2,3). A range of slots is
separated with a hyphen (
0–7). The primary path of the disks must be on the
specified PCI slot number(s).
–pt <item>
Specifies one or more ports. Ports are identified by one or more integers (item).
Multiple ports are separated with a single comma (1,2,3). A range of ports is
separated with a hyphen (
0–4). The primary path of the disks must be on the
specified port number(s).
–cg <item>
Specifies one or more drive cages. Drive cages are identified by one or more integers
(
item). Multiple drive cages are separated with a single comma (1,2,3). A range of
drive cages is separated with a hyphen (
0–3). The specified drive cage(s) must
contain disks.
NOTE: An item is specified as an integer, a comma-separated list of integers, or a
range of integers specified from low to high.