3PAR InForm® OS 2.3.1 CLI Reference (320-200166 Rev B, March 2010)

10.16
Command Line Interface Reference InForm OS Version 2.3.1
port
Specifies the Fibre Channel port number of the PCI card in the specified PCI bus slot
using
1 through 4.
<IP_address>
Specifies the IP address for a Remote Copy interface.
<gateway_address>
Specifies the gateway address for a Remote Copy interface.
<netmask>
Specifies the netmask for a Remote Copy interface.
<MTU_size>
Specifies the MTU size for a Remote Copy interface using an integer from 100 to 9000.
If no integer is specified, the value defaults to
1500.
<speed> half|full
Use only with the rcip speed subcommand. Specifies the speed setting (10, 100, or 1000)
and duplex setting (
half or full) for a Remote Copy interface. In addition to this
specifier, you must also specify an interface using
<N:S:P>. If no speed or duplex settings
are specified, or if you specify
auto with the rcip speed subcommand, the system auto-
negotiates the speed and duplex.
<connmode> disk|host|rcfc
Specifies whether the port is used for a disk, host, or RCFC connection. This specifier must
be used when issuing the
config command.
RESTRICTIONS
■ Access to all domains is required to run this command.
■ The –m <mode> option for the rst subcommand cannot be specified if there are active
connections already using the port (that is the port online) except as noted in the following
section under port pair protection.
■ Port pair protection:
◆ For dual-port LSI Fibre Channel adapters, both ports in the pair must use the same mode
(initiator or target).
◆ For quad-port LSI Fibre Channel adapters, each ports pair (ports 1 and 2, ports 3 and 4)
must use the same mode.