3PAR InForm® OS 2.3.1 CLI Reference (320-200166 Rev B, March 2010)

10.15

InForm OS Version 2.3.1 Command Line Interface Reference

–ct

Sets the connection type. The specified port will be reset.

SPECIFIERS

<ctval>

Specifies the connection parameter of the port. Parameters can be loop or point. The

loop parameter sets the port to arbitrated loop mode, the point parameter sets the port

to point-to-point mode. This specifier must be provided when issuing the

ct subcommand.

Specifies the Fibre Channel Class-2 parameter of the port. Parameters can be one of ack0,

ack1, or disable. This specifier must be provided when issuing the cl2 subcommand.

Specifies the data rate of the Fibre Channel port. Rates can be one of 1, 2, 4, or auto. 1 sets

the data rate to 1 GBps,

2 sets the data rate to 2 GBps, and 4 sets the data rate to 4 GBps.

The

auto parameter sets the port to autodetect the data rate. This specifier must be used

when issuing the

rate subcommand.

Specifies the value of the VCN. The VCN value can be set as enable or disable. This

specifier must be used when issuing the

vcn subcommand.

Specifies the IMP port attribute. The IMP value can be set as enable or disable. This

specifier must be used when issuing the

imp subcommand.

Specifies if interrupt coalescing is enabled or disabled. The value can be set as enable or

disable. This specifier must be used with the intcoal subcommand.

<N:S:P>

Specifies the port to be controlled.

node

Specifies the node using a number between 0 and 7.

slot

Specifies the PCI bus slot in the specified node using a number between 0 and 5.