3PAR InForm® OS 2.3.1 CLI Reference (320-200166 Rev B, March 2010)

10.9
InForm OS Version 2.3.1 Command Line Interface Reference
COMMAND
controlport
DESCRIPTION
The controlport command controls all aspects of a Fibre Channel or Remote Copy port,
including the port’s connection type and data rate.
AUTHORITY
Super, Service
SUBCOMMANDS
config
Sets the specified connection mode and type on FC ports. Also allows setting the unique
node WWN option for the port. When unique_nwwn is enabled, the port presents a unique
node name on the connection and this is needed by certain initiators such as ONTAP.
rst
Resets a port.
offline
Holds the specified port offline indefinitely. Issue controlport rst to bring the port
back online.
lip
Specifies that a Loop Initialization Primitive (LIP) command is issued from the port if there is
a private loop topology. If the
–c option is specified, then the LIP command is issued
through the specified drive cage. If there is a point-to-point topology, then the link is reset.
If there is a public loop or fabric topology, then a Registered State Change Notification is
issued to the fabric controller.
ct
Sets the connection type. The specified port will be reset. See Specifiers on page 10.15 for
parameters required to issue this subcommand.
This option has been deprecated and will be removed in a subsequent release.
NOTE: You need access to all domains in order to run this command.