3PAR InForm® OS 2.2.4 CLI Administrator's Manual (320-200113 Rev A, March 2009)

14.3
Registering a Management Console
InForm OS Version 2.2.4 3PAR InForm OS CLI Administrator’s Manual
14.3 Registering a Management Console
To register the manager with the agent, use the addsnmpmgr command followed by the
manager’s IP address. If you need to use one of the following options, enter it after the
command and before the IP address.
 -p <port_number> - Specifies the port number where the manager receives traps. The
default port 162.
 -pw <password> - Specifies the manager’s access password, if the manager has one.
 -r <number> - Specifies the number of times the system will attempt to resend the trap if
the manager is not available. You can specify from 1 to 15 retries. The default is 2.
 -t <seconds> - Specifies the number of seconds to wait between retries. You can set this
timeout from 1 to 300 seconds. The default is 200.
14.3.1 Viewing Registered Managers
Use the InForm CLI command showsnmpmgr to see which managers are already registered
with the SNMP agent.
NOTE: For all InForm CLI commands used in this section, refer to the InForm OS
Command Line Interface Reference for additional information and examples.
NOTE: The InForm OS supports a maximum of 10 registered SNMP managers.
NOTE: If the manager that monitors the storage server has changed, you need to
remove the old manager and register the new one.