3PAR InForm® OS 2.2.4 CLI Administrator's Manual (320-200113 Rev A, March 2009)

10.6
Physical Disk Capacity
3PAR InForm OS CLI Administrator’s Manual InForm OS Version 2.2.4
10.3.3 Determining a Single Physical Disk’s Capacity
Physical disk capacity can be filtered by disk ID to display a specific disk’s capacity information.
X To display the capacity information for a single physical disk, issue the
showpd -space <PD_ID> command, where <PD_ID> is the physical disk whose capacity
information is shown.
NOTE: The output for the command listed below is displayed in the same format
as the
showpd -space command output example in 10.3.1 Determining Total
Physical Disk Capacity on page 10.4.