3PAR InForm Operating System 2.3.1 Release Notes (320-200178 Rev D, May 2010)

3.16
3PAR InForm Operating System Release Notes InForm OS Version 2.3.1
setrcopygroup ■ The –nopromote option is now accepted for the
reverse and failover disaster recovery commands. It
is no longer accepted for the recover and restore
commands.
■ The –nosync option is now accepted for the recover,
restore, and failover disaster recovery commands. It
was previously only accepted for the recover
command.
■ The –nostart option is now accepted for the
recover, restore, and failover disaster recovery
commands. It was previously only accepted for the
recover and restore commands.
■ The –nosnap option is now accepted for the recover,
restore, and failover disaster recovery commands. It
was previously only accepted for the recover and
failover commands.
■ The –t option is now accepted on the pol
subcommand in addition to all of the disaster
recovery subcommands.
■ The command now no longer blocks waiting for
completion on all specified groups. Instead, the
command will create a task for each group. A new
-waittask option provides the ability to wait for all
operations on all groups to complete.
■ New –discard option for the failover disaster
recover subcommand specifies not to check a
group's other targets to see if newer data should be
pushed from them if the group has multiple targets.
startrcopygroup New –t option provides the ability to start a group
on only the specified target. By default, a group will
be started on all targets.
stoprcopygroup New –t option provides the ability to stop a group
on only the specified target. By default, a group will
be stopped on all targets.