3PAR CIM API Programming Reference for InForm OS 2.3.1 (320-200164 Rev B, February 2010)

4.2
CLI Command Overview
CIM API Programming Reference InForm OS Version 2.3.1
4.1 CLI Command Overview
The following CLI commands are available to manage the 3PAR CIM Server:
4.2 Enabling and Disabling the CIM Server
By default, the CIM Server is disabled and must be manually enabled by an administrator
before it can be used.
4.2.1 Enabling the CIM Server
To enable the 3PAR CIM Server, issue the startcim command:
Table 4-1. CLI Commands Used to Manage the 3PAR CIM Server
Command Purpose Required
Permission Level
setcim
Sets properties of the CIM Server.
This command can be used to
enable or disable certain services.
Super
showcim
Displays status information for
the CIM Server.
Any
startcim
Enables the CIM Server. Super
stopcim
Disables the CIM Server. Super
NOTE: Refer to the 3PAR InForm OS Command Line Interface Reference for
additional information.
# startcim
CIM server will start in about 90 seconds.