HP 3PAR VMware ESX Implementation Guide

3. Select a controller and then press Enter.
4. On the Controller Configuration screen, select Network Configuration and then press Enter.
5. On the Network Configuration screen, select Configure Static IP Address and then press Enter.
The screen for setting a static IP address appears.
Figure 6 Setting a Static IP Address
6. Type the IP address, subnet mask, default gateway and then click Save to return to the Controller
Configuration menu.
If the configuration will boot from SAN instead of from the host, follow these steps:
Adding a iSCSI Target
1. Get the IQN for the card from the iSCSI Initiator Configuration screen, and then create a host
definition on the HP 3PAR StoreServ Storage. For example:
# createhost –iscsi –persona 11 Esx50Sys1 iqn.1990-07.com.emulex:a0-b3-cc-1c-94-e1
2. Assign a VLUN to this host definition that will be used as the SAN boot LUN.
3. On the Controller Configuration menu, select Controller Properties.
4. On the properties screen, verify that boot support is enabled. If it is not, scroll to Boot Support
and enable it, then save and exit this screen.
5. On the Controller Configuration menu, select iSCSI Target Configuration.
6. Select Add New iSCSI Target and then press Enter.
7. Fill in the information for the first iSCSI target. Make sure Boot Target is set to Yes.
Hardware iSCSI Support 23