HP 3PAR Service Processor Software 4.1.x Release Notes (QR482-96666)

8 Service Processor Software 4.1.0 P006, 4.1.0 MU1
P007, and 4.1.0 MU2 P008 Releases
What’s New in the Service Processor
This patch release provides the following:
• Provides additional checks to make sure that SP patches are applied to the intended release
versions (for SP 4.1 MU1 and SP 4.1 MU2)
• Allows you to disable Permissive mode on the firewall by using SPOCC or SPMAINT
• Allows you to change the Customer Controlled Access setting by using SPOCC
• Fixes an issue in which the SP may stop sending files to headquarters while running in Secure
Network Mode
• Increases the maximum file size that can be uploaded to the HP Call Home datacenter from
1 GB to 2 GB
These patches are available as self-install packages for deployment to Secure Network Mode
devices (available internally to HP only).
The following table describes which patch should be installed based on the current level of Service
Processor software that you are running.
Applicable PatchCurrent SP Software Level
SP-4.1.0.GA-60.P006SP 4.1.0 GA, SP 4.1.0 GA+P001, or SP 4.1.0 GA+P001+P002
SP-4.1.0.GA-78.P007SP 4.1.0 MU1
SP-4.1.0.GA-97.P008SP 4.1.0 MU2
NOTE:
• SP-4.1.0.GA-60.P006 includes SP-4.1.0.GA-60.P003. Review the notes for the SP 4.1.0
P003 patch release.
• SP-4.1.0.GA-60.P007 includes SP-4.1.0.GA-60.P004. Review the notes for the SP 4.1.0
P004 patch release.
• SP-4.1.0.GA-60.P008 includes SP-4.1.0.GA-60.P005. Review the notes for the SP 4.1.0
P005 patch release.
Modifications to the Service Processor
The following issues have been addressed in this release.
DescriptionItemIssue ID
While running in Secure Network Mode, the Service Processor may
stop sending files to headquarters (HQ). This issue usually occurs after
File transfer overdue for 3PAR
StoreServ
90479
network connectivity to HP HQ has been lost and then recovered. The
Service Processor resumes sending pings to HQ, but files are not sent
from the SP to HQ. This patch allows the Service Processor to continue
sending files once connectivity to HQ is re-established.
This patch increases the maximum file size that can be uploaded to
the HP Call Home datacenter from 1 GB to 2 GB. Any file that is
larger than 2 GB requires manual intervention to upload the file.
SP did not upload crash dump files
and Insplores
90128
What’s New in the Service Processor 23