HP 3PAR Service Processor Software 4.1.x Release Notes (QR482-96666)

SP Setup wizard retains setupusr password even though MOB was not completed
(Issue 84154)
If you have successfully set the password for the setupusr account and verified it with a
re-authentication as part of SP Setup wizard process, then even if the SP Setup wizard does not
complete and the wizard is restarted (for example, because of an IP address conflict), you must
enter the password that you just configured for the setupusr account. This is expected behavior.
HP 3PAR OS 3.1.2 MU1 CLI client is not backward compatible (Issue 84400)
You must install HP 3PAR OS version 3.1.2.278 on the Service Processor if it is not already installed.
After HP 3PAR OS 3.1.2.278 is installed on the Service Processor, install HP 3PAR OS version
3.1.2.322 (MU1) onto the Service Processor. Then, upgrade the HP 3PAR StoreServ Storage
System to version 3.1.2.322 (MU1).
SPMAINT line 189: read: read error: 0: Input/output error (Issue 84401)
SPMAINT can go into an error loop when you run it from a command line while simultaneously
running it from SPOCC and attempting to start file transfer activity from both sessions. In this case,
you must use press CTRL+C to terminate the SPMAINT command line session.
Message: “Installer not found in distribution. Switching to generic installer” (Issue
85150)
This message is for informational purposes only and may be safely ignored.
Node time mismatch when using SP as NTP server (Issue 84536)
The use of the SP as an NTP server is not supported.
Custom user account has issues on SPOCC but not SPMAINT TUI (Issue 85305)
InSplore and SPLOR processes may not work correctly when a user account name that contains
capital letters is used in SPOCC.
Workaround: Use only lowercase letters when creating user account names.
Setting password in SPMAINT resulted in error: “sh: -c: line 0: syntax error near
unexpected token ‘|’” (Issue 85457)
A valid password is between 7 and 32 characters long and uses only alphanumeric characters
and the following special characters:
• Period (.)
• Forward slash (/)
• Plus sign (+)
• Equals sign (=)
• Hyphen (-)
SP public network NIC settings failed to update eth0 to 1000HD on DL320e (Issue
85548)
On an HP ProLiant DL320e, changing the NIC setting of eth0 back to 1000FD after changing to
a different NIC speed causes a failure to update eth0 to 1000FD.
Workaround: Select the default setting instead of 1000FD.
Known Issues in the Service Processor 15