HP 3PAR Service Processor Software 2.5.x Release Notes (QR482-96663)

13 Service Processor Software 2.5.2 P412 Release
The following release notes are for the Service Processor Software 2.5.2 P412 release of the HP
Service Processor.
What’s New in the Service Processor
Patch SP-2.5.2.GA.11.412 is used to upgrade Service Processors from version 2.5.1 or 2.5.2 to
version 4.1.0.GA-97 (MU2). This patch supersedes all previous SP 2.5.2–to–SP 4.1.0 upgrade
patches and contains the combined SP 4.1.0 payload, which includes SP-4.1.0.GA-97 (MU2).
This patch can be installed from SPMAINT when the Service Processor is in SP mode.
The SP 4.1.0 MU2 release includes the following enhancements:
• After upgrading to SP 4.1.0 MU2, Service Processors that are configured in Secure Network
Mode (Axeda) will be automatically reconfigured to connect to new servers at HP.
• Starting with SP 4.1.0 MU2, all newly configured Service Processors (both physical and virtual)
will have a Service Processor ID (SP ID) that is based on the serial number for the HP 3PAR
StoreServ Storage system that is attached to the Service Processor. The SP ID will not be
changed for upgraded (legacy) Service Processors.
NOTE: After you install this patch, you must upgrade to Service Processor software version 4.1.0.
This patch is not revertible after installation.
NOTE: Only the Supermicro II SP is supported for upgrade to SP 4.1.0 from SP 2.5.x.
What’s New in the Service Processor 21