Event Log Message Reference Guide 2013/06

55
Event Log Messages
930 Slot Link failure: Fabric <module>
has faulty link to Slot <slot-num>
warning A fault on a line card prevents it from connecting to fabric. The
error may be recoverable.
RMON_CHASSIS_FABRIC_FAIL_LC
931 Fabric failure: link error between
Fabric <module> and Slot <slot-
num>
warning The fabric blade has a faulty link to a slot in the chassis. The error
may be recoverable.
RMON_CHASSIS_FABRIC_FAIL_FABRIC
932 chassis: Unknown fabric failure:
link between Fabric <module>
and Slot <slot-num> down
warning The link between a fabric blade and a slot has an error that can’t
be traced to either the fabric or the slot without further testing.
RMON_CHASSIS_FABRIC_FAIL_EITHER
933 Chassis running at reduced
backplane capacity
info The switch is operating with fewer active fabrics than required to
maintain the backplane’s full capacity.
RMON_CHASSIS_FABRIC_LOW_CAP
934 Chassis has no active fabrics.
Line cards resetting.
warning There are no active fabric modules. They are either not present,
failed, or disabled.
RMON_CHASSIS_FABRIC_NOT_AVAIL
935 Fabric <blade> disabled via the
configuration setting.
info The indicated fabric module is disabled via SNMP or the
command line interface (redundancy fabric-module disable)
RMON_CHASSIS_FABRIC_DISABLED
936 Fabric <blade> enabled info The indicated fabric module is enabled via SNMP or the command
line interface (redundancy fabric-module enable)
RMON_CHASSIS_FABRIC_ENABLED
937 Fabric <blade> inserted info The fabric blade has been inserted or first detected at boot.
RMON_CHASSIS_FABRIC_INSERT
938 Fabric failure: Fabric <blade-
name> is not responding
warning A fabric blade is not responding on the SRI.
RMON_CHASSIS_FABRIC_NOT_RESPONDING
939 Fabric failure: Fabric <blade-
name> failed selftest
warning The fabric blade indicated failed selftest.
RMON_CHASSIS_FABRIC_ST_FAIL
940 Fabric failure: Fabric <blade-
name> power failure
warning The fabric blade’s power supply has failed.
RMON_CHASSIS_FABRIC_POWER_FAIL
941-
942
Reserved
943 Filter-rule length greater than 80
char MAX, list-index <list-num>
rule-index <rule-num>
warning The filter-rule’s length exceeded the 80 character maximum.
RMON_DCA_RULE_PARSE_LENGTH_ERROR
944 Filter-rule parsing error. permit/
deny keyword, list-index <list-
num> rule-index <rule-num>
warning There was an error with the permit/deny keyword while parsing
the filter rule entry.
RMON_DCA_RULE_PARSE_PERMIT_KWD_ERROR
945 Filter-rule parsing error. “in”
keyword, list-index <list-num>
rule-index <rule-num>
warning There was an error with the “in” keyword while parsing the filter
entry rule.
RMON_DCA_RULE_PARSE_IN_KWD_ERROR
# Message Severity Description