Event Log Message Reference Guide 2013/06

31
Event Log Messages
542 system: Runtime Error Skipped:
<err-msg>
info Skips the runtime error messages that are not being used.
RMON_SYSTEM_ERR_SKIP
543-
548
— — Reserved
RMON_XXX_UNUSED5 - 16
549 Insufficient power supplies to
power Slot <slot-num>
warning The slot is not receiving sufficient power.
RMON_CHASSIS_POWER_INSUFFIENT
550 <slot-num> Module Present info A module is installed in the specified slot. The chassis manager
sees the inserted module.
RMON_CHASSIS_MODULE_PRESENT
551 <slot-num> Module failed self
test
warning The module installed in the specified slot failed its self-test.
RMON_CHASSIS_MODULE_ST_FAIL
552 Module insertion detected:
Reboot required
warning A new module has been installed and you must now reboot the
switch to activate the module.
RMON_CHASSIS_MODULE_HS_DETECTED
553 Over-temperature detected.
Failures: <num>
warning An over-temperature condition in the switch has been detected
or the RPS is failing. The number of switch failures is displayed
RMON_CHASSIS_OVERTEMP
555 RPS state: <slot-num>.
Failures: <num>
warning A failure in the redundant power supply in the specified slot has
been detected. The number of power failures is displayed.
RMON_CHASSIS_RPS_STATUS
556 Power Supply is <slot-num>.
Failures: <num>
warning A failure in the single power supply in the specified slot has been
detected. The number of power failures is displayed.
RMON_CHASSIS_SINGLE_POWER_STATUS
557 Temperature back to normal.
Failures: <num>
info The over-temperature condition has passed and the chassis
temperature is normal. The number of power failures is displayed.
RMON_CHASSIS_TEMP_NORMAL
558 NMI Error: <msg-txt> warning The message identifies the subsystem that has triggered the NMI
error. NMI non-maskable interrupt errors occur when a
subsystem requires use of the CPU for an unusually long time.
RMON_CHASSIS_NMI_ERR_LOG
559 <msg-txt> warning Used for debugging. Displays a log of an NMI event.
RMON_CHASSIS_BACKPLANE_FAILED
560 Port <port-num> PD Detected. info The switch has detected a Power over Ethernet (PoE) device
connected to the specified port.
RMON_POEMGR_PD_DETECTED
561 Port <port-num> Applying Power
to PD.
info A PoE device is connected to the port and receiving power.
RMON_POEMGR_PD_APPLY_POWER
562 Port <port-num> PD Over Current
indication.
warning The powered device (PD) connected to the port has requested
more than 15.4 watts of power. This may indicate a short-circuit
or other problem in the PD.
RMON_POEMGR_PD_OVERCURRENT
# Message Severity Description