Basic Operation Guide 2013/06
Table Of Contents
- Switch Software
- Contents
- 1 Commands found in the Basic Operation Guide
- 2 Getting started
- 3 Using the Menu Interface
- 4 Using the Command Line Interface (CLI)
- Overview
- Accessing the CLI
- Using the CLI
- Return message types with CLI commands
- CLI interactive commands
- CLI control and editing
- 5 Using the HP WebAgent
- 6 Switch memory and configuration
- Overview
- Configuration file management
- Using the CLI to implement configuration changes
- Creating a custom default configuration
- Using the menu and WebAgent to implement configuration changes configuration file
- Zeroization
- Using Primary and Secondary flash image options
- Multiple configuration files
- Display configuration of selected interface
- Automatic configuration update with DHCP Option 66
- 7 Interface access and system information
- 8 Configuring IP addressing
- Overview
- IP configuration
- Loopback interfaces
- IP Preserve: retaining VLAN-1 IP addressing across configuration file downloads
- Configuring a single source IP address
- 9 Software management
- Downloading switch documentation and software from the web
- Viewing or downloading the software manual set
- Downloading software updates for your switch
- Software signing and verification
- Saving configurations while using the CLI
- Important: Best Practices for software updates
- Updating the switch: overview
- Updating the switch: detailed steps
- Rolling back switch software
- Viewing or transferring alternate configuration files
- Downloading switch documentation and software from the web
- Index
Table 1 List of commands (continued)
PageCommand
18menu
40redo
71reload after
71reload at
79rename config
41repeat
37session interactive-mode
36session show-message-type
107show <ip | ipv6>
15show banner
90show config
77show config files
90show config interface
51show config status
96show console
136show flash
116show ip route
124show ip source-interface
73show reload
84show running-config
84show running-config interface
38show session
102show system information
64show version
103snmp -server <contact | location>
78startup-default
97telnet
96telnet-server
104time
104time daylight-time-rule
104time timezone
29vlan
98web-management
52write memory
51write terminal
8 Commands found in the Basic Operation Guide