Basic Operation Guide 2013/06
Table Of Contents
- Switch Software
- Contents
- 1 Commands found in the Basic Operation Guide
- 2 Getting started
- 3 Using the Menu Interface
- 4 Using the Command Line Interface (CLI)
- Overview
- Accessing the CLI
- Using the CLI
- Return message types with CLI commands
- CLI interactive commands
- CLI control and editing
- 5 Using the HP WebAgent
- 6 Switch memory and configuration
- Overview
- Configuration file management
- Using the CLI to implement configuration changes
- Creating a custom default configuration
- Using the menu and WebAgent to implement configuration changes configuration file
- Zeroization
- Using Primary and Secondary flash image options
- Multiple configuration files
- Display configuration of selected interface
- Automatic configuration update with DHCP Option 66
- 7 Interface access and system information
- 8 Configuring IP addressing
- Overview
- IP configuration
- Loopback interfaces
- IP Preserve: retaining VLAN-1 IP addressing across configuration file downloads
- Configuring a single source IP address
- 9 Software management
- Downloading switch documentation and software from the web
- Viewing or downloading the software manual set
- Downloading software updates for your switch
- Software signing and verification
- Saving configurations while using the CLI
- Important: Best Practices for software updates
- Updating the switch: overview
- Updating the switch: detailed steps
- Rolling back switch software
- Viewing or transferring alternate configuration files
- Downloading switch documentation and software from the web
- Index
Rebooting from the menu interface
• Terminates the current session and performs a reset of the operating system
• Activates any configuration changes that require a reboot
• Resets statistical counters to zero
To Reboot the switch, use the Reboot Switch option in the Main Menu. (Note that the Reboot Switch
option is not available if you log on in Operator mode; that is, if you enter an Operator password
instead of a manager password at the password prompt.)
Figure 16 The Reboot Switch option in the Main Menu
Rebooting To Activate Configuration Changes. Configuration changes for most parameters become
effective as soon as you save them. However, you must reboot the switch in order to implement a
change in the Maximum VLANs to support parameter.
(To access these parameters, go to the Main menu and select 2. Switch Configuration, then 8.
VLAN Menu, then 1. VLAN Support.)
If configuration changes requiring a reboot have been made, the switch displays an asterisk (*)
next to the menu item in which the change has been made. For example, if you change and save
parameter values for the Maximum VLANs to support parameter, an asterisk appears next to the
VLAN Support entry in the VLAN Menu screen, and also next to the Switch Configuration … entry
in the Main menu:
Using the menu and WebAgent to implement configuration changes configuration file 61