Basic Operation Guide 2013/06
Table Of Contents
- Switch Software
- Contents
- 1 Commands found in the Basic Operation Guide
- 2 Getting started
- 3 Using the Menu Interface
- 4 Using the Command Line Interface (CLI)
- Overview
- Accessing the CLI
- Using the CLI
- Return message types with CLI commands
- CLI interactive commands
- CLI control and editing
- 5 Using the HP WebAgent
- 6 Switch memory and configuration
- Overview
- Configuration file management
- Using the CLI to implement configuration changes
- Creating a custom default configuration
- Using the menu and WebAgent to implement configuration changes configuration file
- Zeroization
- Using Primary and Secondary flash image options
- Multiple configuration files
- Display configuration of selected interface
- Automatic configuration update with DHCP Option 66
- 7 Interface access and system information
- 8 Configuring IP addressing
- Overview
- IP configuration
- Loopback interfaces
- IP Preserve: retaining VLAN-1 IP addressing across configuration file downloads
- Configuring a single source IP address
- 9 Software management
- Downloading switch documentation and software from the web
- Viewing or downloading the software manual set
- Downloading software updates for your switch
- Software signing and verification
- Saving configurations while using the CLI
- Important: Best Practices for software updates
- Updating the switch: overview
- Updating the switch: detailed steps
- Rolling back switch software
- Viewing or transferring alternate configuration files
- Downloading switch documentation and software from the web
- Index
Example 95 The show ip source-interface command Output
HP Switch(config)# show ip source-interface
Source-IP Configuration Information
Protocol | Admin Selection Policy IP Interface IP Address
-------- + ----------------------- ------------- ---------------
Tacacs | Configured IP Interface vlan 22
Radius | Configured IP Address 10.10.10.2
Syslog | Configured IP Interface vlan 10
Telnet | Outgoing Interface
Tftp | Outgoing Interface
Sntp | Outgoing Interface
Sflow | Outgoing Interface
The show ip source-interface detail command displays detailed information about the configured
policies, source IP address, and interface state for each protocol.
Syntax:
show ip source-interface detail [ radius | sflow | sntp | tacacs |
telnet | tftp | syslog ]
Displays detailed operational status information for the source IP address selection
policy. Information about the configured policies, source IP address and interface
state are displayed.
When no parameters are specified, policy information for all protocols is displayed.
124 Configuring IP addressing