Brocade Fabric OS Documentation Addendum v6.1.2_cee (53-1001216-01, June 2009)

38 Fabric OS Documentation Addendum

53-1001216-01

ESW-1006

Message <timestamp>, [ESW-1006], <sequence-number>,, WARNING, <system-name>, HA state out

of sync: Standby CP (ver = <standby SWC version>) does not support NPIV

functionality. (active ver = <active SWC version>, NPIV devices = <'1' if NPIV

devices exist; Otherwise '0'>).

Probable Cause Indicates that the standby control processor (CP) does not support N_Port ID Virtualization (NPIV)

functionality, but the switch has some NPIV devices logged into the fabric.

Recommended

Action

Load a firmware version on standby that supports NPIV functionality, using the firmwareDOwnload

command.

Severity WARNING

ESW-1007

Message <timestamp>, [ESW-1007], <sequence-number>,, WARNING, <system-name>,Switch port

<port number> disabled due to \"<disable reason>\".

Probable Cause Indicates that the switch port is disabled due to the reason displayed in the message.

Recommended

Action

Based on the disable reason displayed, take appropriate action to restore the port. Insufficient

frame buffers: Reduce the distance or speed settings for the port to reduce the buffer requirement

of the link. Alternatively, one or more ports in the port group must be disabled to make more

buffers available for the link. Refer to the Fabric OS Administrator's Guide for more information.

Severity WARNING

ESW-1008

Message <timestamp>, [ESW-1008], <sequence-number>,, WARNING, <system-name>,<area string>

are port swapped on ports that do not support port swap. Slot <slot number> will

be faulted.

Probable Cause Indicates that the blade has area swapped ports on ports that do not support this feature.

Recommended

Action

Replace the blade with ports that support port swap. Refer to the Fabric OS Administrator’s Guide

for more information.

Severity WARNING

New chapter, FCOE System Messages

A new chapter titled FCOE System Messages was added after the FCMC System Messages chapter

and before the FCPD System Messages; it contains all the new messages for the new feature, FCoE

module.