Brocade Fabric OS Documentation Addendum v6.1.2_cee (53-1001216-01, June 2009)

Fabric OS Documentation Addendum 11
53-1001216-01
FCoE
2
FCoE
Manages and displays FCoE configuration.
Synopsis fcoe --cfgshow [port]
fcoe --disable port
fcoe --enable port
fcoe --loginshow port
fcoe --fcmapset -vlan vid fcmapid
fcoe --fcmapunset -vlan vid
fcoe --fipcfg -advintvl intvl
fcoe --fipcfgshow
fcoe --resetlogin [-teport slot/port | -device wwn ]
fcoe --help
Description Use this command to configure and display the status of FCoE Ports, FCoE Initialization Protocol
(FIP), and FCMAP settings.
Unlike regular FC ports, FCoE Ports are embedded interfaces that are not directly associated with
an external physical port on the switch. Although show commands such as switchShow display
FCoE Ports as “ports,” configuration of these ports through the regular FC CLI is disabled. Only the
fcoe CLI commands can be used.
There are six configurable FCoE Ports on the Brocade 8000 switch.
Operands This command has the following operands.
port Specifies the port number. There are six configurable embedded FCoE Ports
on the Brocade 8000, and the valid range for port is 8 to 13.Use switchShow
for a list of valid FCoE Ports.
--help Displays command usage.
--cfgshow Displays the configuration of a specified embedded FCoE Port. If a port is not
specified, the command displays all port configurations.
--disable Disdables the specified FCoE Port.
--enable Enables the specified FCoE Port.
--loginshow Displays information about the devices logged into the specified FCoE Port.
--fcmapset Configures the FCMAP values for Fabric Provided MAC Addresses (FPMA) for
the specified VLANs.
-vlan vid Specifies the VLAN for which to set the FCMAP.
fcmapid Specifies the FCMAP to be set.
--fcmapunset Unsets the FCMAP for a specified VLAN. Devices previously logged in are
disconnected.
-vlan vid Specifies the VLAN ID for which the FCMAP is unset.